8/10/2019 Aceleradores Eletronicos Variaveis

1/2

Boat-50A-BEC/Boat-70A-BEC/

Boat-100A-BEC/Boat-100A/Boat-

125A/Boat-200APhrases 1 Enter programming Mode

1. Connect your motor and receiver to the speed controller, but do not connect the battery yet.

2. Turn on your transmitter and move the throttle stick to the full throttle position (full up). Please Note !ost "utaba

transmitters have the throttle channel reversed by default.

#. Connect your battery and the controller $ill initiali%e $ith a musical tone.

Phrases 2 Programming

&fter # seconds, the controller $ill start beepin' a seuence of tones a musical tone follo$ed by one or more beeps. *ach

seuence represents a parameter that you can pro'ram and is repeated # times. The parameters are

+ Music Tone 1 -eep ptions 1. Cell Type and No. of Cells

+ + MusicTone 2 -eeps ptions 2. Throttle /ettin'

+ + + MusicTone # -eeps ptions #. -rake /ettin' 0Throttle type (for eli)

+ + + + MusicTone -eeps ptions . 3irection and Cutoff Type

+ + + + + MusicTone 4 -eeps ptions 4. Timin' !ode

+ + + + + + MusicTone 5 -eeps ptions 5(PWM) Setting

Step 1. Starting, Enter Sub-optins. 6hen you hear the seuence for the parameter you $ish to pro'ram, move the throttle stick to the

Center Position to Enter Sub-options.

The controller $ill then start beeping aMorse code sequence of short and lon' beeps representin' the possible options you

may choose for the selected parameter. /ee table 2 for a list of all pro'rammable options. *ach option seuence is repeated #

times.

Step 2. Select and save, the select the option, move thetrottle stic!back tote "ull-up-position., 6hen you hear the seuence for the

option you $ish to select. The controller $ill then save the selected option, andsound a long beep as a con#ir$ation.7t then 'oes

back to the be'innin' of the pro'rammin' seuence (phrases 2).

Step %. Co$plete progra$$ing and save options . /etup all the parameters you need to chan'e. 6hen complete, move the throttle stick

to the &o'est (o'n) Position. The controller $ill save all options and re8initiali%e in normal runnin' mode so you can start

your motor.

e table belo' su$$ari*es te various progra$$ing options #or eac para$eter+

is e#ault Setting

1.+ "or (2S-S)-ESC

Cell pe and /u$ber o# Cells

9 + 1 /hort 1 :on' Ni!h0NiC3 &uto Cell Count 8 ;./ :i8Po (24.?=) 21= Cutoff =olta'e

9 + + + 1 /hort # :on' 5/ :i8Po (22.2=) 1.=)

8/10/2019 Aceleradores Eletronicos Variaveis

2/2

2. rottle Setting + +

99 + 2 /hort 1 :on' &uto Throttle @an'e A

99 + + 2 /hort 2 :on' 1.1ms to 1.